Solder paste Mixer SR-500

Solder paste Mixer SR-500

Stirring, defoamation and deaeration take place within a few minutes. The adjustment of viscosity is also optimized through step stirring
  • Overview

      Solder paste Mixer SR-500

       

      ・Can immediately prepare cold stored solder paste without bringing it back to room temperature
      ・By optimizing the mixing recipe, viscosity preparation and temperature preparation for solder paste is easy.
      ・Removes large air bubbles in the paste, which are considered the cause of solder paste defects.
      ・Handles commercial 500g solder paste containers as is
      ・Restirs and redisperses solder paste that has been used
      ・Supports solder paste in syringes by using the optional adapter

  • Benefits and Features

      Feature

      Can prepare uniform viscosity in a short time for solder paste just taken from cold storage without bringing it back to room temperature. Metal particles with high specific gravity such as solder particles settle to the bottom of containers in cold storage and cause differences in material viscosity. The SR-500 regulates the viscosity of solder paste in a short time, with uniform viscosity from top to bottom. Also, because it can remove air bubbles thought to cause spattering of solder balls, it contributes to reducing the defect rate.

      Specification

      Unit Dimensions/ Unit weight

      H390 ×W300×D340(mm) Approx. 18kg

      Maximum Capacity*1
      *1:Total mass to mount on the cup holder, including materials, containers, and adapters.

      680g

      Standard Container*2
      *2:Contact us because the actual volume of mixing may vary depending on the containers, materials, and conditions.

      150 ml resin container

      Power Supply

      Voltage: Single-phaseAC 120 V ± 10 %, 50/60 HzPower consumption:Approx. 50 VA (standby)Max 900 VA (operation)

      Accessories

      Instruction Manual × 1,AC cable (including 3P adapter) × 1,150 ml container × 3,Adapter for HDPE 150 ml container × 1(including 1 O-ring)Silicon rubber sheet × 1,O-ring for fine adjustment × 11 metal fitting is attached to the unit rear to release the lid lock, in case of power failure.

       

       

       

       

       

       

       

       

       

       

       

       

  • Enhanced Technology